3.Press and release the 
CD Tray button to close the CD Tray. If you wish, you may also leave the CD Tray open and it will automatically close at the start of the print job. Once printing is complete, the CD Tray will automatically
In order for the printer to print properly, CD media must be installed. If you accidentally attempt to print without installing any media, the CD Tray will open and the printer will pause until media is loaded and the CD Tray is closed. When closing the CD Tray, do not manually push on the front of the tray to
close it. Instead, always press the 
CD Tray button to open or close the CD Tray.
IMPORTANT! After you have loaded the CD media, you must also select the appropriate Media option from within the printer driver setup window. Please refer to Section 3 or 4 for more information on selecting printer driver settings.
D. PRINTING A SELF TEST
Now that the printer is set up and print supplies are loaded, a self test should be performed to check for proper operation of the printer. A sample of the self test print is shown below. Refer to the following steps to run a self test:
1.If power is ON, turn it OFF now. The Power light should be OFF. Verify that print supplies are installed and that the CD Tray is closed. Also, disconnect the interface cable from the printer if connected.
2.With the printerÕs front cover shut, press and hold the
CD Tray button as you turn the printer power ON.
3.Continue to hold the 
CD Tray button down for approximately 8 seconds, until you hear the self test begin to print.
8 Ink Cartridges and Printable CDÕs