Primera Technology Automated Optical Disc Printing System Ink Saturation, Calibration Options

Page 20

TOC

INDEX

Ink Saturation

This option controls the ink saturation of the printed image. When printing onto the printer manufacturer's TuffCoat CD media, this option can be left at its default setting of 100%.

When printing onto other brands of printable CD media, you may need to adjust this control in order to optimize the ink saturation for the printable surface of your specific CD media. Click on the up and down arrows to change the ink saturation setting. Lower numbers reduce the overall ink saturation, while higher numbers increase it. If discs do not seem to be drying completely it may be necessary to reduce this value.

Calibration Options

Click on the plus to reveal the following four Calibration options.

Inner Diameter

This value changes the size of the non-printed center. Larger numbers cause the non-printed center to be larger and smaller numbers make the non-printed center smaller. This number is incremented by 0.1mm so a change of 10 for inner diameter changes the diameter by 1mm. Set the diameter to 230 for Primera TuffCoat media.

Cartridge Alignment

The Cartridge Alignment prints a test print and then automatically scans the print to configure your printer for bidirectional printing and to align the color and black cartridges for Color+Black printing. It is important to perform this calibration every time you change a cartridge. If you forget to perform this calibration you will be prompted to do so before your first print from the new cartridge.

Center The Print Image

NOTE: Your printer comes from the factory pre-calibrated to print the image in the center of the CD. You can use this adjustment if you need to fine-tune this location.

If you ever wish to verify your factory-calibrated Vertical and Horizontal calibration settings, you can run a simple calibration procedure to assure that your images will be

16Printing Discs on a PC

Page 19 Page 21
Image 20
Page 19 Page 21
Contents For Macintosh and PC Printing History Table of Contents Interactive Feature Choosing a Good Location Getting StartedThank YOU… Unpacking and Inspection Identifying the Parts Front Panel and TopRear Panel PC System RequirementsMAC System Requirements TOC Index Hardware and Software Setup Installing the PC SoftwareInstalling the MAC Software Set-UpLoading Media Discs Hardware SetupApplying Power TOC Index Connecting the USB 2.0 Cable/Installing the Driver If you are using a PCIf you are using a Macintosh Installing Ink Cartridges Do not Touch the Copper AreaSetting UP the Printer Driver Printing Discs on a PCPaper Size Resolution Non-printable Outer MarginDisc Surface Quality Cartridge TypeInk Saturation Calibration OptionsInner Diameter Cartridge AlignmentBack Change Cartridges Enable Ink Low WarningClean/Change Cartridges & Check Ink Levels Disc Output Location Clean/PurgeDetails Creating a Print Label Using Surething Printing from Other Graphics Programs Using Kiosk Mode TOC Index Printing Discs on a Mac Printed Label Format RequirementsPrinting from ANY Application Printer OptionsPrint Settings Cartridge to use Print QualityDisc Surface Quality IntensityConfig Utility Save As DefaultRestore Defaults Configuration UtilityClean Cartridge Image Alignment Change CartridgeAlignment Calibration Print Tough lines whose TOC Index Interpreting the Printers Indicator Lights LEDCleaning the INK Cartridges MaintenanceCleaning the Printer Clearing a Media JAM Transporting the PrinterTechnical Specifications DVD-R, DVD RAM, DVD+R, DVD+RIndex
Top Page Image Contents