After draining is complete, close the drain valves

SILVER RECOVERY

Publications on silver management that include recommendations and descriptions of silver-recovery options are available in the Silver Management section of the Kodak Environmental Services Publication Center at www.kodak.com/go/KES .

DRAINING AND MIXING FRESH

REPLENISHERS

If you need to drain and mix fresh replenisher solutions, follow this procedure:

1.Empty the remaining replenisher solutions by using the drain valves at the bottom of the machine

2.After draining is complete, close the drain valves.

Note for FUJI FRONTIERS only:

It is necessary to add water to the developer replenisher tank. Add this instruction to those above:

2A. Pour 500 mL of water into the developer (the slot farthest to the left) in the cartridge-loading section.

3.Insert a full cartridge into the slot and make replenishers by following the standard procedure given for the processor model used.

Example: Loading dock of FUJI FRONTIER Processor

Pour 500 mL of water into this position when making replenisher after completely draining replenisher tanks.

Note: If you forget to add the water and receive an error message (E-2675) when you prepare fresh replenisher, you can add the water after the replenisher has been mixed. The water addition is only necessary when the replenisher tank has been drained; it is not required for routine mixes with the cartridge.

Using the KODAK EKTACOLOR Processing Cartridge 111 with Digital Minilabs, CP-48S/CP-49E CIS-229E