Installing the CD Record Utility

3 Installing a jumper on the master/slave select terminal

Connect a jumper to the rear side of the CD-R/RW.

If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it will work in the Slave mode.

If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal CSEL. (In general, connection to MA is recommended.)

CS : Cable Select(CSEL)

SL : Slave

MA: Master

4 Connecting the audio cable from a sound card

Connect the 4-pin audio cable between the sound output terminal on the CD-R/RW drive and the audio input terminal on the sound card.

For clearer sound, use a digital output terminal. (Available only for the CAID that supports digital output) This may not be available for general sound cards.

Sound Card

Sound Output Terminal Digital Output Terminal

Audio Input Terminal

of the Sound Card

To record data on a CD-R or CD-RW disc in the CD-R/RW drive, you must first install the CD record utility. For compatibility reasons, you are recommended to uninstall any existing software of the same type before installing this utility.

1 Insert the disc supplied with the CD-R/RW drive in the drive.

2 Follow the instructions displayed on the screen to install the utility. Refer to the separate utility documentation for further details.

3 Store the utility disc in a safe place.

Installing the Device Driver

No additional device driver is needed for Windows 98/2000/ME/XP/NT4.0,

as the default Windows device driver is used. You can check that the CD-R/RW drive has been correctly detected by Windows. To do so, proceed as follows.

1 Double-click on the My Computer icon on your desktop.

2 Double-click on the Control Panel folder.

3 Double-click on the System icon.

4 Click on the Device Manager tab.

5 Expand the CD-ROM branch.

The SAMSUNG CD-R/RW SW - *** device name is displayed.

The SAMSUNG device driver enables discs in the CD-R/RW drive to be read but not recorded in an MS-DOS environment; the driver is located in the D driver folder on the CD record utility disc.