8. Operation | Preparation |
|
|
Preparation
General
1.Press the Stand by button to switch on the projector.
– The Standby indicator lights up green and the start up screen appears
for several seconds.
–When the average
Some examples:
Data |
| Video |
|
| No signal |
lamplife time has almost expired and less than 100 hours remain, the message ‘Warning: lamplife has almost expired’ will be displayed on the screen when switching the projector on. For this refer to the section ‘Lamp’ under ‘Maintenance’
2.Select the required source (Data, Video or
Note: When only one input source is connected, this source will automatically be selected. When more input sources are connected, the source with the highest priority will be selected (data, video,
3.Switch on the computer or start video playback.
–A feedback message appears on the screen, indicating the selected source.
Data selected as source.
A/V Muted
Video selected as source, no input signal.
Video
A/V Muted
Video selected as source. A/V muted.
Messages - General explanation
Messages are
displayed in the centre of
the screen. The problem is | Fan error |
|
described in the header of | The projector will switch off automatically. |
the message display. |
|
On Screen Display menu - General explanation
All video and data adjustments and settings (except A/V Mute) are done via On Screen Displays and with help of Menu, OK and Cursor Control on the projector or the remote control.
Suggestion(s) to solve the problem are displayed in the gray part of the message display.
These messages cannot be suppressed.
Feedback messages
Please contact a service centre for repair.
1.Press Menu.
– The menu bar appears on |
The first item |
is highlighted and its |
sub menu is shown. |
Depending on the |
selected source (Data, |
Video or |
options of the submenu |
may be greyed out. This |
indicates that these |
the screen.
Display Picture Audio Settings
Digital Freeze
Digital Zoom
Magnification
Auto Image
Horizontal size
Phase
Shift
Feedback messages are displayed in the top right corner of the screen. They are displayed when:
–a signal comes up or goes down,
–when an input source is changed,
–when Mute or A/V Mute is activated,
–when the Auto image function is set to On.
functions: |
– are not available in a |
certain mode, |
– have no function for |
the selected source. |
Off | On |
Auto Image is used to automatically adjust Horizontal Size, Phase and Shift.
These messages will only be displayed when the menu option Feedback is set to ‘On’ in the Settings menu. All messages will be removed automatically after 4 seconds.
For example:
–Horizontal size under menu Display when Auto image is switched to ON.
–Hue under menu Picture when signaltype is not NTSC.
15