Setup
Connecting the power cable
The
1 +5V DC
2 Ground
A - Cut Side3 Ground 4 +12V DC
Note: An improperly connected power cable may cause trouble. Check the direction of the power connector and the incline side of the COMBO drive before connecting.
Connecting the E-IDE cable
Insert the IDE cable
When using one E-IDE cable
Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear of the COMBO drive.
a: Slave Drive (Choose the SL Jumper)
b: Hard Drive
c: MainBoard
When using two
If there is only one COMBO drive, select MA (Master).
a | : Master Drive (Choose the MA Jumper) | b | : Hard Drive | English - 10 | |
|
|
|
| ||
c | : MainBoard | d | : Primary 1 | ||
| |||||
|
|
|
|
| |
e | : Secondly 1 |
|
|
|