Philips LC4331, LC4345, LC4341 manual Operation Preparation, For example

Please contact a service centre for repair.

The projector will switch off automatically.

Fan error

Actionwindow

Submenu highlight

Submenu

Menubar

On Screen Display menu - General explanation

All video and data adjustments and settings (except A/V Mute) are done via On Screen

Displays and with help of Menu, OK (–/––) and Cursor Control on the projector or the remote control.

Multimedia Projectors

8. Operation Preparation

Preparation

General

1.Press the Stand by On button to switch on the projector.

– The lamp indicator flashes green and the

start up screen appears for several seconds.

–When the average

lamplife time has almost PHILIPS expired and less than

100 hours remain, the

message ‘Warning: lamplife has almost expired’ will be displayed on the screen when switching the projector on. For this refer to the section ‘Lamp’ under ‘Maintenance’

–When the lamp is on, the lamp indicator lights up green.

2.If you use the trackball remote control:

–Set the ON/OFF switch of the remote control to ON in order to switch on the remote control.

–If required, press the light button of the remote control. When this button is pressed, the button illumination is switched on for 5 seconds. Every time one of the buttons is pressed within these 5 seconds, the illumination time is extended by a further 5 seconds.

3.Select the required source (Data, Video or S-Video) by pressing the Source button.

4.Switch on the computer or start video playback.

–A feedback message appears on the screen, indicating the selected source.

Messages - General explanation

Messages are

displayed in the centre of the screen. The problem is described in the header of the message display. Suggestion(s) to solve the problem are displayed in the gray part of the message display.

These messages cannot be suppressed.

Feedback messages

Feedback messages are displayed in the top right corner of the screen. They are displayed when:

– a signal comes up or goes down,
– when an input source is changed
–	when Mute or A/V Mute is activated.
–	when the Auto image function is set to On.

Some examples:

Data	Video
	No signal

Data selected as source.		Video selected as source, no
		input signal.
	S-Video		S-Video
	A/V Muted		A/V Muted

S-Video selected as source.	Video selected as source.
A/V muted.	A/V muted.

1.Press Menu.

–The menu bar appears on the screen. The first item

is highlighted and its sub

menu is shown. Display Picture Audio Settings

These messages will only be displayed when the menu option Feedback is set to ‘On’ in the Settings menu. All messages, will be removed automatically after 4 seconds.

Depending on the selected source (Data, Video or S-Video) some options of the submenu may be greyed out. This indicates that these functions:

–are not available in a certain mode,

–have no function for the selected source.

Digital Freeze

Digital Zoom

Magnification

Pan...

Keystone correction

Auto Image

Horizontal size...

Phase

Shift...

Off On

Auto Image is used to automatically adjust Horizontal Size, Phase and Shift.

For example:

–Horizontal size under submenu Display when Auto image is switched to ON.

–Hue under submenu Picture when signaltype is not NTSC.

15