Philips LC4341, LC4331 manual Set Up, Positioning the projector and screen, Mains supply, To Raise

6. Set Up

Positioning the projector and screen

• Place the projector on a stable, level surface, out of direct

sunlight and away from sources of excessive dust, dirt, heat,

water, moisture, vibration and strong magnetic fields.

Face the projector towards the screen for the best picture

results. To determine the distance for the desired size,

please refer to the Projection Assistant, a calculation

programme included on the CD-ROM.

• The screen should be positioned so that it is not directly

touched by sunlight or artificial light, as this will wash out the

colours of the picture, making it hard to see.

• The projector can be used for both front projection, rear

projection and ceiling projection applications. As default

factory setting, the projector has been set up for front

projection. You can change to rear or ceiling projection via the

OSD menu. See ‘Rear screen projection’ and ‘Ceiling-mount

projection’ under ‘Operation - Display and picture control’ for

–The Standby Warning screen will appear for 20 seconds.

Warning

If the projector is switched off you have to wait 1 minute before you can switch on the projector again.

To switch off projector keep stand-by key pressed for 3 seconds.

Press OK key to remove this warning.

	further instructions.
•	Choose a screen size suitable for the number of viewers and
	the size of the room.
•	Picture quality is best when you sit directly in front of the
	projector screen.

Mains supply

1.Insert the mains lead into the projectors Power socket and connect it to the wall socket.

Note: The standby indicator lights up red, the projector is now in the Power/Standby mode.

Note: The Stand by Warning screen can be removed by keeping the Stand by On button pressed for 3 seconds.

If the Stand by On button is pressed for 3 seconds the first time (step 3), the projector is switched back into the power standby mode without the Standby Warning screen being displayed.

5.To switch off the mains supply completely, pull the mains plug out of the wall socket.

Note: Before disconnecting the mains lead, make sure that the

cooling fan has stopped (about 3 minutes after the projector has been switched to Power Standby).

Adjusting the focus and size of the image

•Use the Zoom ring to adjust the size of the image.

•Use the Focus ring to adjust the focus of the image.

Zoom ring

Focus ring

2.Remove the lens cap.

3.Press the Stand by

On button to switch on

the projector.

–The lamp indicator flashes green.

–When the projection lamp is on, the lamp indicator lights up green while the lamp is starting up and the start-

up screen appears for several seconds.

4.Press the Stand by On button again to switch the projector back into the power standby mode.

PHILIPS

Multimedia Projectors

Adjusting the vertical and horizontal angle of the projector

Vertical angle

•Use the Height/Level Adjusters to adjust the vertical angle of the projector as specified under ‘Positioning the projector and screen’.

A	A
B	B

To Raise:

•Keep both adjusters (A) pressed and lift to raise the projector.

– The projector feet (B) will come out.

8