Operation
1.Remove the lens cap.
2.When switching on, first switch on the projector and then the computer. Press any button on projector or remote control to switch on the projector. The Standby indicator lights up orange. Then, when the projection lamp comes on, the Standby indicator lights up green and the
3.Select the required source, Computer, by pressing the Source button repeatedly
4.Turn on the computer.
Adjusting
•Use the Zoom ring to adjust the size of the image.
•Use the Focus ring to adjust the focus of the image.
•To raise: Keep knob A pressed and lift to raise the projector. The Height/Level Adjuster B will come out.
•To lower: Keep knob A pressed and gently lower the projector.
•If projector and screen are not properly placed, the picture will be distorted, producing a keystoned image (picture top width larger than picture bottom width or vice versa). ‘Keystone correction’ allows you to correct picture distortion of the vertical keystone type by internal scaling. This correction function is accessible through the ‘Keystone Correction’ option in the ‘Settings’ menu of the On Screen Display (OSD) menu.
•Pressing the menu button will give you access to many setting that can be adjusted including: zoom, brightness, contrast, color temperature, volume, bass, treble, keystone correction, lamp life, and more.
Standby Mode
Please put the projector in the Power/Standby position if you are not going to use the projector for more than 15 minutes. When no signal inputs are detected for 30 minutes, the projector automatically switches to Power/ Standby (Auto Standby).
1.Press the Standby button to switch the projector back into the Power/Standby mode. The Standby Warning screen will appear for 20 seconds.
2.Press the Standby button again to confirm.
3.The projector will now go into Power/Standby mode. You can also press the Standby button twice in succession to switch the projector into Power/Standby mode immediately.