Philips PCA103CD user manual Installing Your Drive

Page 19

INSTALLING YOUR DRIVE

audio) connector, labeled “Audio.” The unlabeled jumpers on both models are for factory testing only.

6.Plug a free IDE connector inside your PC into the drive’s socket. The cable’s colored edge must be aligned with the Pin 1 position.

Note: If you have a sound card that has an IDE port, you can either connect the CD-ROM drive to your PC or to the sound card. You must then disable the unused secondary IDE port. See Appendix A for what a secondary IDE port is and refer to your sound card, PC or IDE controller manual for the instructions on disabling the unused secondary IDE port.

7.If you have a sound card with a 4-pin CD-ROM audio connector, use the supplied audio cable to connect it to the drive’s “” connector (the “” connector on PCA103CD).

2

5

Image 19

Contents Philips CD-ROM Drive Table of Contents Copyrights And Liabilities Printed Taiwan Iii FCC Notice USAS.F1. Regulatory Statement CDC Regulatory Statement CanadaPage Belangrijke veiligheidsvoorschriften Important Safety NoticeVii Avis important en matière de sécuritéWichtiger Sicherheitshinweis Page Precauzioni Importanti Importante Advertencia de Seguridad INTRODUCTION1 FeaturesSystem Requirements Package ContentsPage Installing the CD-ROM Drive Installing Your DriveInserting the CD-ROM Drive Installing Your Drive If You Are a DOS or Windows 3.x User Letting Your System Recognize DriveIf You Are a Windows 95 User Insert the Installation diskette into a 3.5 floppy driveFolder contents are You If You Are an OS/2 Warp User System Configuration Dialog Box Following window appears 10 OS/2 Window 213This page is intentionally left blank Manually Controlling the Drive Drive ApplicationsPlay/skip CD IDE Connections Master or a Slave DEVICE?Philips CD-ROM Drive USER’S Manual Figure A-2 Enhanced IDE Controller Card 186 197 Slave Mode Master Mode Setting Master and Slave Jumpers1721 Reliability Audio FeaturesInterface PerformanceFront panel Physical Characteristics