Philips SNA6500 Flags Indicates the route status, Fragmentation half-open wait, Internet

Page 39

EN

Flags

Indicates the route status:

 

 

C = Direct connection on the same subnet.

 

 

S = Static route.

 

 

R = RIP (Routing Information Protocol) assigned route.

 

I = ICMP (Internet Control Message Protocol) Redirect route.

Flooding cracker block time.

Default 300 sec: Length of time from detecting a flood attack to blocking the attack.

Fragmentation half-open wait

Default 10 sec: Configures the number of seconds that a packet state structure

 

remains active. When timeout value expires, the router drops the

 

unassembled packet, freeing that structure for use by another packet.

Gateway

Displays system IP settings, as well as DHCP Server and Firewall status.

Gateway

The IP address of the router at the next hop to which frames are forwarded.

Gateway

Enter the WAN IP address of the gateway to the remote network.

Group Key Re-Keying

The period of renewing broadcast/multicast key.

Half-open fragmentation detect

Default 10000 msec: Length of time before a half-open fragmentation session is

sensitive time period.

is detected as half-open.

 

Home networking

Sets the TCP/IP configuration for the ADSL Wireless Base Station LAN interface and

 

DHCP clients.

 

Incomplete TCP/UDP sessions

Default 250 sessions: Maximum number of allowed incomplete TCP/UDP sessions

(per min) HIGH

per minute.

 

Incomplete TCP/UDP sessions

Default 200 session: Minimum number of allowed incomplete TCP/UDP sessions

(per min) LOW

per minute.

 

Information

Displays the number of attached clients, the firmware versions, the physical MAC

 

address for each media interface, and for the ADSL Wireless Base Station, as well as

 

the hardware version and serial number.

 

Interface

The WAN interface to be configured.

 

Incomplete TCP/UDP sessions detect

Default 300 msec: Length of time before an incomplete TCP/UDP session is detected

as incomplete.

sensitive time period.

 

Interleaved Path CRC Error

The number of Interleaved Path Cyclic Redundancy Check errors.

Interleaved Path HEC Error

Interleaved Path Header Error Concealment errors.

IP Address

The IP address of the ADSL Wireless Base Station.

IP Subnet Mask

The subnet mask of the network.

 

IP Address

Traps are sent to this address when errors or specific events occur on the network.

Internet

Displays WAN connection type and status. Click the Connect button to connect to

 

your ISP.

 

Interface

The local interface through which the next hop of this route is reached.

Key Entry Method

Select Hex or ASCII code for encryption

key generation.

Key Provisioning

Select Static if there is only one fixed key for encryption.

 

If you want to select Dynamic, you would need to enable 802.1x function first.

Lease Time

Set the IP lease time. For home networks this may be set to Forever, which means

 

there is no time limit on the IP address lease.

 

Loss of Signal Defect

Momentary signal discontinuities.

 

Maintenance

Contains options to backup & restore the current configuration, restore all

 

configuration settings to the factory defaults, update system firmware, or reset the

 

systems.

 

Maximum half-open fragmentation

Default 30: Maximum number of half-open fragmentation packets from the same

packet number from same host

host.

 

39

Image 39
Contents SNA6500 Page LAN Ports Power InletReset Button Adsl PortTable of Contents Internet Access About the Adsl Wireless Base StationFeatures and Benefits Wireless and Wired LANImportant information Safety PrecautionsPackaging contents SecurityHardware Description LED IndicatorsISP Settings System RequirementsPhone Line Configuration Connect the SystemConnect the Adsl Line TCP/IP Configuration Windows 98/MeDepending on your operating system TCP/IP Configuration Setting Disable Http ProxyInternet Explorer Obtain IP Settings from Your Adsl Wireless Base Station Windows NT TCP/IP Configuration Setting Windows Windows XP Configuring Your Macintosh Computer Configuring your wireless adapter Getting Started Setup WizardWireless settings Adsl settingsConnection Status Parameters Adsl / Internet settingsISP settings Adsl StatusURL Blocking Access ControlFirewall MAC FilterIntrusion Detection Intrusion Detection Feature Schedule RuleConnection Policy Wireless Encryption Wireless security802.1X WPAStatus Home network settingsNetwork settings WirelessWDS WEP Special Applications Advanced settingsAddress Mapping Virtual ServerSystem MaintenanceSnmm Trap Remote ManagementSnmp Community Parameter DescriptionTraffic mapping Upnp Universal Plug and Play settingsDdns Dynamic DNS settings QoSRouting table RoutingStatic route parameter RIP parameterMAC address Windows NT4/2000/XPMacintosh LinuxWizard Network Settings Page For Windows 98SE and Windows Me Page Click ‘OK’ to accept the changes Key by watching RIP packets All of its wireless clientsStation and all of its wireless clients ServerPer min High Per minute Incomplete TCP/UDP sessions Flags Indicates the route statusFragmentation half-open wait Dhcp clients Incomplete TCP/UDP sessionsSuch as video transmission Downstream signalMetric An interleaver is basically a buffer usedStatistics UDP session idle timeoutSpecifies the Internet connection settings Wait between failed authenticationsSettings will be lost, also your ISP settings Problem SolutionPhysical Characteristics Environmental March SNA6500Page SLA5500 Guarantee certificate Certificado de garantia Garantibevis