Fujitsu FTP-622DSL001/011/012 manual Connector PIN Assignment, Connector for power supply CN10

FTP-622DCL/DSL

■CONNECTOR PIN ASSIGNMENT

1. Connector for power supply (CN10)

Part number			: B6P-VH (J.S.T)
Mating connector part number : VHR-6N (J.S.T) or equivalent
No.	Signal	I/O	Contents	No.	Signal	I/O	Contents
1	VCC	—	Power supply for logic (+5 V)	2	GND	—	GND (5 V, 24 V common)
3	GND	—	GND (5 V, 24 V common)	4	GND	—	GND (5 V, 24 V common)
5	VDD	—	Power for head/motor (+24 V)	6	V DD	—	Power for head/motor (+24 V)

2. Connector for thermal head drive (CN8)

Part number				: B16B-PH-K-S (J.S.T)
Mating connector part number : PHR-16 (J.S.T) or equivalent
No.		Signal	I/O	Contents	No.		Signal	I/O	Contents
1	VDH		O	Power for head (+24 V)	2	VDH		O	Power for head (+24 V)
3	GND (VDH)		—	Head GND	4	GND (VDH)		—	Head GND
5	STB1		O	Print enable signal 1	6	STB2		O	Print enable signal 2
7	STB3		O	Print enable signal 3	8	TMP		I	Temperature detection signal
9	STB4		O	Print enable signal 4	10	LAT		O	Print data latch signal
11			O	Print enable signal 5	12	5 VH		O	Power for logic (+5 V)
	STB5
13	HCLK		O	Data transmission clock	14	HD		O	Print data output signal
15	GND (VDH)		—	Head GND	16	VDH		O	Power for head (+24 V)

Notes:

•Symbol “——” means a negative logic signal.

•“I” or “O” means a signal direction from the interface board side.

3.Connector for Sensor (CN3)

Part number			: B5B-PH-K-S (J.S.T)
No.	Signal	I/O	Contents	No.		Signal	I/O	Contents
1	+5 V	—	Power for logic (+5 V)	2	PES		I	Paper end detect signal
3	GND (5 V)	—	Logic GND	4	+5 V		—	Power for logic (+5 V)
5	HUP	I	Head-up detect signal

3