Fujitsu FTP-622DSL001/011/012, FTP-622DCL001/011 manual Connector for paper near end detection CN5

FTP-622DCL/DSL

4. Connector for paper near end detection (CN5)

Part number			: B2B-PH-K-S (J.S.T)
Mating connector part number : PHR-2 (J.S.T) or equivalent
No.	Signal	I/O	Contents	No.	Signal	I/O	Contents
1	+5 V	—	Power for logic (+5 V)	2	NES	I	Paper near end detect signal

5. Connector for stepping motor drive (CN13)

Part number			: B4B-PH-K-S (J.S.T)
No.	Signal	I/O	Contents	No.	Signal	I/O	Contents
1	MT/B	O	Stepping motor coil excitation	2	MT/B	O	Stepping motor coil excitation
3	MT/A	O	Stepping motor coil excitation	4	MT/A	O	Stepping motor coil excitation

6. Connector for cutter drive (CN11) *1

Part number			: B4B-EH (J.S.T)
No.	Signal	I/O	Contents	No.	Signal	I/O	Contents
1	SW1	I	Cutter position detect signal	2	GND	—	Logic ground
3	M+	O	Motor control signal (+)	4	M-	O	Motor control signal (-)

*1: Only for FTP-622DCL011/111.

5