Black Box ServSwitch DT Series USB/DVI/Audio KVM Switches, KV9612A

Table 4-1 (continued). Hotkey commands.

Key Sequence	Function
Left-Ctrl + Left-Ctrl + F3	To adjust Scan Rate, this command sets the
	duration before switching to the next computer
	in AutoScan.
	The 4-Port ServSwitch DT Series generates 1 to
	4 beeps, indicating a scan interval of 3, 8, 15,
	and 30 seconds respectively.
Left-Ctrl + Left-Ctrl + F5	Audio Stick: You can link an optional multime-
	dia module to the back of each KVM switch to
	select microphone and stereo speaker signals.
	There are two options for Audio Stick: ON and
	OFF. When set to ON, audio selection follows
	computer selection. When set to OFF, audio
	selection stops following computer selection.
	The ServSwitch beeps once for ON and twice
	for OFF. Use this to listen to a particular com-
	puter’s audio signal while operating other com-
	puters.
Left-Ctrl + Left-Ctrl + A	Press this key sequence to select audio for the
	chosen computer. (Use when Audio Stick set to
	Off.)
Left-Ctrl + Left-Ctrl + U	Press this hotkey to select the USB port (for
	both 2-port and 4-port ServSwitch).

USB port setting for 2-port ServSwitch:

Left-Ctrl + Left-Ctrl + F7 Press this hotkey to turn ON/OFF the USB1 and USB2 ports on the console side.

USB port setting for 4-port ServSwitch:

Left-Ctrl + Left-Ctrl +F7 Press this hotkey to turn ON/OFF the USB1 port on the console side.

Left-Ctrl + Left-Ctrl + F8 Press this hotkey to turn ON/OFF the USB2 port on the console side.

Page 18

Black Box ServSwitch DT Series USB/DVI/Audio KVM Switches, KV9612A, KV9614A manual AutoScan