Black Box KV9612A, KV9614A manual Alternate Hotkey Commands, Function Button 4-Port Only

Chapter 4: Operation

NOTE:  There are two options for USB Port Rule: ON and OFF. When set to ON, USB-Port selection follows computer selection. When set to OFF, USB-Port selection stops following USB port selection.

NOTE: Make sure the USB device linking procedure has finished before switching to another computer.

4.4 Alternate Hotkey Commands

In addition to the Left-Ctrl + Left-Ctrl hotkeys, there are two other hotkey sequences programmed into the ServSwitch:

Hotkey sequence #1: Left-Ctrl + Left-Ctrl + _

Hotkey sequence #2: Scroll-Lock + Scroll-Lock + _

Hotkey sequence #3: Hold Left-Shift + Num-Lock + Num-Lock + _

For keyboards that don’t have or won’t support Scroll Lock, press and HOLD the Left-Shift key, and then press the Num-Lock key twice. For example, to select a computer:

Hold Left-Shift + Num-Lock + Num-Lock then release Shift and press 1. This selects the computer at Port 1.

Hold Left-Shift + Num-Lock + Num-Lock then release Shift and press 2. This selects the computer at Port 2.

4.5 Function Button (4-Port Only)

Use the Function button on the front panel (#5 in Figure 2-3) to adjust the video signal strength according to the length or quality of DVI cable. It also selects the audio signal from any of the connected computers’ four ports.

To adjust the video signal strength, follow these steps:

1.Press the Function button three times.

2.Press push button #1 one or two times to adjust the selected port’s input video strength. One beep = normal or two beeps = enhance.

or

Press push button #3 one or two times to adjust the selected port’s output current. One beep = normal or two beeps = enhance.

or

724-746-5500 blackbox.com Page 19