Black Box RS-232/422/485, RS422/485 manual Installation

Page 12

CHAPTER 3: Installation

Figure 3-1. System Properties screen, Device Manager tab.

You can access your new COM ports by using the assigned COM identifiers as shown in Figure 3-1. In this case, it is COM3, 4, 5, and 6. However, this assignment will vary from system to system. At this point, the hardware is recognized and ready to use.

Image 12

Contents July IC1020A IC1021A IC1022A Federal Communications Commission DUAL- and QUAD-PORT USB Hubs EMC Directive StatementNOM Statement DUAL- and QUAD-PORT USB Hubs Trademarks Contents Specifications Introduction OverviewWhat’s Included Technical DescriptionConnector Pin Assignments Signal Name Pin # ModeSignal Name Installation Operating System InstallationSystem Installation Installation Configuration Original ConfigurationElectrical Interface Selection Jumpers E5, E6, E7, and E8Switch SW4 Settings Jumper Port RS-232 RS-422/485Switch Switch SW3 SettingsDescription RS-485 RS-422 Switch Port Description RS-485 Switch SW2 and SW4 SettingsSwitch SW1 and SW3 Settings Port Description RS-485 QUAD-PORTUSB HUB-RS-232/422/485 IC1022AJumpers E1, E2, E3, E4, E5, E6, E7, and E8 Switch Setting Port Description RS-485 RS-422Setting Appendix A. Troubleshooting Troubleshooting TipsCalling Black Box Shipping and PackagingAppendix B. Electrical Interfaces RS-232RS-422 RS-485 Figure C-1. Bit diagram for asynchronous communication Appendix C Asynchronous CommunicationAppendix C Asynchronous Communication Copyright 2002. Black Box Corporation. All rights reserved