Samsung MPS-50 owner manual Connections

INPUT

Note: You can connect audio equipment with a stereo or monaural plug. When you connect a stereo plug, the MPS-50 converts the stereo output to monaural.

Use a phone cable (available at your lo- cal RadioShack store) with a 1/4-inch (6.35 mm) plug to connect an electric guitar, keyboard, or high impedance mi- crophone to the HIGH input jack of Channel 1 and/or Channel 2.

Use a phone cable with a 1/4-inch (6.35

mm)plug to connect a low impedance (200–600 ohms) microphone to the LOW jack of Channel 1 and/or Channel 2.

To receive signal from the connected device, connect a phone cable with a 1/4- inch (6.35 mm) plug to the MPS-50’s RETURN jack, then connect the other end to the device’s output jack.

REVERB REMOTE

You can connect an optional remote footswitch to the MPS-50’s REVERB RE- MOTE jack and use the switch to control reverb effects.

OUTPUT

To play the MPS-50's output signal through your sound system, connect one end of an audio patch cord (avail- able at your local RadioShack store) with a 1/4-inch (6.35 mm) phone plug to the MPS-50's LINE OUT jack. Then con- nect the other end to your amplifier/re- ceiver/mixer's input jack.

POWER

Note: Before you connect the MPS-50 to AC power, set POWER to the off (out) position and MASTER to MIN.

Connect the female jack end of the sup- plied power cord to the AC jack on the back of the MPS-50, then connect the other end to a standard AC outlet.

SEND AND RETURN

To send the MPS-50's signal to a sound effect device, such as an echo reverb or digital sampler processor, connect a phone cable (available at your local Ra- dioShack store) with a 1/4-inch (6.35 mm) plug to the MPS-50’s SEND (output) jack, then connect the other end to the sound effect device’s input jack.