Fujitsu XG0224 manual Prepare a Setup PC, Log on using the terminal software, Setting

XG0224 Hardware Guide Chapter 2 Installation

Prepare a Setup PC

Log on using the terminal software.

1.Start up the terminal software by using the set up PC.

2.Set the setting conditions to the following;

Item	Setting
Start Bit	1
Data Bit	8
Parity Bit	n/a
Stop Bit	1
Synchronous System	Asynchronous Communication System (Start-Stop Communication System)
Communication Speed	9600
Flow Control	None
Number of digits on screen	80 (If other than 80 digits, set it through terminal command)
Number of rows on screen	24

Please refer to the terminal software manual for instructions on setting conditions.

3.Press [Return] key or [Enter] key.

Precautions

The following message may appear When pressing the [Return] key or [Enter] key. In such case, the switch is processing another job, and waiting for such process to finish. Please wait for a moment until it finishes such process. Waiting for completion of the other operation...

4.Confirm “Login :” on screen.

5.Key in “admin” and press [Return] key or [Enter] key.

6.Confirm “Password:” on screen.

7.Key in password, then press the [Return] key or [Enter] key.

Since password is not set at the initial state, simply press [Return] key or [Enter] key without keying in the password. If the password is already set, key in the password. Then press [Return] key or [Enter] key.

8.Confirm “#” is shown on screen

If the key in the wrong password, "invalid password." will be displayed, then the "Login :" will be displayed again. Please repeat your process from item 5.

43 Connecting to a Setup PC