Black Box Cable Length Meter, CLM5000 manual Installing the Battery

Page 23

Chapter 5: Installing the Battery

5. Installing the Battery

Batteries are not included. Use only an alkaline 9-volt battery. When installing a new battery, disconnect any test cables connected to the Cable Length Meter. (See Figure 5-1.)

1.Using a #2 Phillips screwdriver, unscrew the battery cover screw and remove the battery cover on the back of the unit.

2.Remove the old battery from the battery compartment and detach the battery cap.

3.Connect a new alkaline 9-volt battery to the battery cap.

4.Slide the battery into the cavity.

5.Close the battery cover and replace the screw. Do not overtighten.

Battery

cover screw

Battery

cover

Cable Length

Meter, back view

Figure 5-1. Battery installation.

724-746-5500 blackbox.com

Page 21

Image 23

Contents December CLM5000 Page Weee Directive Compliance RoHS FCC and IC RFI StatementsInstrucciones DE Seguridad Cable Length MeterNOM Statement Trademarks Used in This Manual Table of Contents Specifications AWG SpecificationsOverview Introduction FeaturesHardware Description OverviewWhat’s Included AL/CU Units Key General Functions PWR Key and Auto Power OffMode Key LCD Display Icons General FunctionsAWG Mode screen Using the Cable Length Meter AWG ModeUsing the Cable Length Meter Pair SGL Key SET LEN Key AWG Mode ExampleUsing the Cable Length Meter Normal Network Measuring screen Coax, Network, and Telco ModesSet Length Mode screen Tone Mode Changing Opens/Capacitance Coefficient Using Set LengthCalibrating the Test Lead Tone Mode screenWire under test Installing the Battery Installing the BatteryShipping and Packaging Troubleshooting Calling Black BoxBlackbox.com Blackbox.com Blackbox.com Black Box Tech Support FREE! Live /7