Black Box PoE PSE Media Converter, LPS500A-MM-SC manual Installation Connecting Hardware

Page 11

Chapter 3: Installation

3. Installation

3.1 Connecting Hardware

The 10/100/1000BASE-T PoE PSE to 1000BASE-X Media Converter requires no software configuration. To install the media converter, follow the steps below:

1.Connect the PSE media converter to an AC power source.

2.Connect a PoE/PD device to the PSE/TP port on the media converter using the appropriate twisted-pair cable. The media converter can also work as a standard media converter when PoE is disabled.

3.Connect the FX port to a fiber network using the appropriate fiber cable.

WARNING: Verify that the AC input conforms to your country’s AC power requirement before inserting the power plug.

10/100/1000BASE-T to 1000BASE-SX/LX PoE Media Converter

Links to PD device

Links to 1000BASE-X fiber network

Figure 3-1. Connecting PSE PoE converter and cables.

724-746-5500 blackbox.com

Page 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents PoE PSE Media Converter, 10/100/1000BASE-T to 1000BASE-SX/LX Blackbox.com NOM Statement Trademarks Used in this Manual Table of Contents Specifications Overview Introduction FeaturesOverview Front and Back Panels What’s IncludedSide Panel DIP Switches and Reset Button LED IndicatorsButton for changes to take effect Installation Connecting Hardware InstallationPoE Endpoint RJ-45 Pin Assignment Endpoint PSE RJ-45 male connectorLink Fault Passthrough Link Fault PassthroughNormal status via one LFP Gigabit Ethernet Fiber switch Cable Connection Parameters Cable Connection ParametersAbout Black Box Black Box Tech Support FREE! Live /7
Top Page Image Contents