Xerox 7300 manual Incomplete Fusing

Problem	Solution
Incomplete Fusing	1.	Open the top cover and make sure the orange fuser
Toner appears to be pulled off print, or is easy ￿		restraint pin is removed and the green lever on the back￿
		side of the Fuser is in the locked positon.
to rub off.	2. Turn the printer off and then on.
	3. From the printer's front panel Support Menu select Improve￿
		Print Quality?, then select Print Paper Tips Page and press￿
		OK.
	4. Ensure the paper you are using is the correct type for the￿
		printer and is properly loaded.
	5. Ensure the paper loaded in the tray matches the paper￿
		type selected on the printer's front panel and in the￿
		computer's printer driver.
	6. If the problem persists: .
		a. From the printer's front panel Printer Setup Menu select￿
		Tray Setup Menu and press OK. Select the tray you are￿
		printing from (i.e., MPT, Tray 1, etc).
		b. Select Set Paper Type and then select Special.
		c. Use the Back button to return to the Tray Setup Menu
		and select Special Paper Setup Menu.
		d. Scroll to a heavier paper type and press OK.
Color Misregistration	1.	Turn the printer off and open the top cover.
Color has shifted outside of the designated ￿		a. Visually inspect the four LED bars for any foreign￿
		material.	a
area or has been superimposed over another
color area.
		b. Visually inspect the Imaging Units and remove any￿
		foreign material if found.

2. Close the top cover.

3.Turn the printer on. The printer will ￿ perform an automatic registration alignment.

Caution: Do not leave the top cover open for more than ￿ 10 minutes without covering the Imaging Unit as damage could result. Use the dark bag that came with the Imaging Unit or dark paper as a cover.

See www.xerox.com/officeprinting/infoSMART on the world wide web for more on-line support information.

Page 3 of 3