Installation planning
For detailed information about defining the printer to your specific host and connectivity requirements, refer to “Preparing for installation” in the DocuPrint NPS/IPS Installation Planning Guide.
Installation process
To efficiently install and set up the NPS/IPS Extension option on your 2000 Series 100/115/135/155/180 EPS system, certain activities need to be performed by you and by Xerox.
Xerox is responsible for the physical installation of the NPS/IPS Extension hardware and IPS/NPS software. The steps in the installation process typically occur in the following order:
1.Xerox personnel install the NPS/IPS software and the NPS/ IPS Extension hardware.
2.Xerox personnel obtain a software license authorizing you to use the IPS/NPS software.
3.Xerox personnel connect the printing system to the network or channel.
4.Xerox personnel and you configure the printing system, clients, or IBM host as applicable to submit jobs.
5.Xerox personnel conduct initial operator training.
For detailed information about the activities that you and Xerox personnel perform during installation, refer to Installation in the Xerox DocuPrint NPS/IPS Installation Planning Guide.
Software licensing
When the NPS or IPS software is purchased, the owner needs a license to use it. Until the license is enabled at the printing system, jobs are not processed and printed.
NOTE: For an NPS/IPS Extension, software licenses are required. Refer to your Xerox DocuPrint NPS/IPS Installation Planning Guide for further information on licenses.
NPS/IPS Extension Operations Guide |