Canon VF-1 dimensions Programming for Photo Sensor Use

Page 13

3 – Pick up the hand set of the touchtone phone con nected to the VendaFax module. Listen for 2 beeps on the speaker of the hand set generated by the VendaFax module.

4 – Once you hear the two beeps, enter the string o f numbers you wish the unit to dial to connect to your outside fax services, followed by #00. You will hear 2 beeps for successful programming, 3 beeps for unsuccessful programming. Number can be up to 32 digits long.

5 – Once you have successfully programmed the numbe r to forward, you need to program the time out for connection to that service. Enter the desired time (in seconds, two digits only) followed by #40. Two beeps indicate successful programming, three beeps indicate unsuccessful programming. Factory default is 10 seconds and should be sufficient for most applications.

6 – Hang up the touchtone phone, reconnect the To F ax line to the VendaFax module. Restore DIP switch #4 to the Normal mode position (off), turn DIP switch #2 to the on position to use the Store and Forward mode of operation. Return the bypass to normal operation. The basic programming of the VendaFax unit is complete.

For special characters or pauses in the dial string, please refer to the chart below for programming.

4 second pause - *7

1 second pause - *8

To enter a * in the dial string - ** To enter a # in the dial string - *# To reset to Factory Defaults - ###

Programming for Photo Sensor Use

There are some fax protocols that cannot be detected by using audio signals and MUST use the supplied photo sensor. After you have installed the sensor, programming must be done to the VendaFax module.

1 – Turn DIP switch #4 to the On position

2 – Disconnect the “To Fax” line and connect a touc htone phone to that jack. Power the VendaFax up. The LED on the face will glow red when power is applied.

3 – Pick up the hand set of the touchtone phone con nected to the VendaFax module. Listen for 2 beeps on the speaker of the hand set generated by the VendaFax module.

4 – Enter *4 on the telephone keypad and wait to he ar 2 beeps from the VendaFax. You have successfully programmed the VendaFax to operate using the Photo Sensor.

5 – Place DIP switch #4 in the off or “Normal Opera tions” mode, reconnect the “To Fax” line and use the system.

Corporate Headquarter: 16381 Cherokee Road Brooksville, Florida 34601 352-796-2693

Factory: 21B Squires St. Cortland, NY 13045 607-428-0627

Image 13
Contents Mounting Guidelines Parts ListPage Wiring Specifications Page Line Connections Page Photo Sensor Mode Page Page Page Programming Page Programming for Photo Sensor Use Programming the Vend Device Basic Operation of Straight Thru Dialing ModeBasic Operation of Store and Forward Mode One-Year Warranty and Service Policy Disclaimer Return Authorizations