Belkin F1DD102L user manual Connect your KVM Switch to the Host PC Step

Page 21

Firmware-Upgrade Guide

Connect your KVM Switch to the Host PC

Step 5.

Now press the first front-panel button on the KVM Switch until you hear three beeps. The KVM Switch has now entered into the upgrade mode.

Step 6.

Check to make sure the KVM cables from port 1 are connected to the host PC.

Note: A special upgrade cable is not needed to perform the upgrade since you can use the same KVM cable that you use for connecting to the computers. However, depending on the different models, the KVM cables you use will vary.

Step 7.

Click the “Browse” button and locate the firmware-upgrade file, which is indicated with a file extension such as “*.blk”.

Select the upgrade file (for example: “UCF-30-11-07.blk”) and click “Open” to load the file. Then click “Upgrade” to make it ready for upload.

1

2

3

4

5

6

7

8

section

19

Image 21
Contents Soho KVM Switch with Audio Table of Contents Introduction Package ContentsOverview Feature OverviewEquipment Requirements Overview Unit Display DiagramsFront View Back ViewSpecifications Pre-Configuration Installing the KVM SwitchStep Connecting the KVM SwitchInstalling the KVM Switch Connect the Audio Audio and Microphone ConnectionsPowering Up the Systems Selecting a Computer Using Direct-Access Port Selectors Using the KVM SwitchHot-Key Preceding Sequence Configuration Using the KVM SwitchAudio & Mic Switching ScrLk + ScrLk + Q LED Information Switching the Audio/Mic Firmware-Upgrade Guide Prepare your KVM Switch and the Host PC Step Upgrade Using the Windows Version UtilityActivate the Firmware-Upgrade Utility Program Step Firmware-Upgrade GuideConnect your KVM Switch to the Host PC Step Begin the File Upload Step Prepare your KVM Switch and the Mac Host Step Upgrade Using the Mac Version UtilityFirmware-Upgrade Guide Firmware-Upgrade Guide Connect your KVM Switch to the Mac Host Step Begin the File Upload Step Firmware-Upgrade Guide Which operating systems does the KVM Switch support? FAQsWhat does flash-upgrade capability mean? What is DDC?FAQs Am getting a black screen on my monitor TroubleshootingMouse is lost when I switch to a different channel TroubleshootingComputer boots up fine, but the mouse does not work Mouse is not detected at boot upAudio and Microphone Progress bar stops for a long time without any advancement Firmware-Upgrade TroubleshootingInformation FCC StatementCE Declaration of Conformity What is not covered by this warranty? What will we do to correct problems?How to get service What the period of coverage isInformation How state law relates to the warrantyBelkin International, Inc Belkin Tech Support Belkin B.V