Installation
Step 4 Powering Up the Systems (required)
4.1Attach the power adapter to the DC power jack labeled “5V, 2.5A” on the back of the Switch. Only use the power adapter supplied with the Switch. (Refer to diagram below.)
4.2Power on your computers and your monitor. All computers can be powered on simultaneously.
Note: Your computers should recognize the Switch and automatically install the HID USB driver if necessary.
When you power on your computers, the Switch emulates both a mouse and keyboard on each port and allows your computers to boot normally. The computer connected to port “1” will be displayed on the monitor. Check to see that the keyboard, monitor, and mouse are working normally. Proceed to do this with all occupied ports to verify that all computers are connected and responding correctly. If you encounter an error, check your cable connections for that computer and reboot. If the problem persists, please refer to the Troubleshooting section in this User Manual.
1
2
3
4
5
6
7
section
13