Belkin F1DL102UTT user manual Installation, Pre-Configuration

Page 5

INSTALLATION

Pre-Configuration

Where to Place the Switch

The Switch is designed for positioning on the desktop. The exact placement will be based on the location of your CPUs and length of your cables.

Cable Distance Requirements

VGA signals are best retained when transmitted up to eight feet. Beyond eight feet, probability of video degradation increases with an increase in distance. For this reason, your USB computer should be placed within eight feet of the KVM Switch.

Cautions and Warnings

Avoid placing cables near fluorescent lights, air conditioning equipment, or machines that create electrical noise (e.g., vacuum cleaners).

6

INSTALLATION

Step-by-Step Installation Guide

This section provides complete instructions for the hardware setup of a single Switch.

Connecting Computers to the Switch

1.Make sure the computer is powered on.

2.Verify that your USB keyboard and mouse work properly with your computer before you install the Switch.

3.Using the attached cables, take the VGA cable and connect it to the VGA port on the first computer.

4.Connect the USB keyboard KVM cable to the keyboard port on the computer.

5. Connect the green speaker KVM cable to the speaker jack on the computer.

6. Connect the pink mic KVM cable to the mic jack on the computer.

7. Repeat steps 1 through 6 for the additional computer to be connected to

the Switch.

7

Image 5
Contents Port KVM Switch Introduction Table of ContentsOperating Systems FeaturesOverview LED Indicators Enclosure Plastic SpecificationsWeight 1.2 lbs Warranty 3 yearsPre-Configuration InstallationConnecting the Console to the Switch FAQsKeyboard TroubleshootingVideo General MouseCE Declaration of Conformity InformationCommutateur KVM à 2 ports Introduction Table DES MatièresIntroduction Vue d’ensembleSystèmes d’exploitation VUE D’ENSEMBLECaractéristiques Spécifications Schéma de l’appareilVoyants DEL Boîtier Plastique Garantie 3 ansÉtape préparatoire InstallationRaccordement de la console au commutateur FAQClavier DépannageVidéo Généralités EN Matière DE Compatibilité Électromagnétique InformationConmutador KVM de 2 puertos Introducción Índice DE ContenidosIntroducción GeneralidadesSistemas operativos GeneralidadesCaracterísticas Especificaciones Diagrama de los indicadores de la unidadIndicadores LED Carcasa plástico Temperatura de funcionamiento de 32 a 104 F de 0 a 40 CInstalación InstallationinstalaciónConfiguración previa Conexión de la Consola al Conmutador Preguntas MÁS FrecuentesTeclado Resolución DE ProblemasImagen General RatónComisión de comunicaciones de Eeuu Información