Belkin F1DS104J manual Firmware-Upgrade Guide, Connect your KVM Switch to the Host PC Step

Firmware-Upgrade Guide

Connect your KVM Switch to the Host PC

Step 4.

Now press the first front-panel button on the KVM Switch until you hear two beeps. The KVM Switch has now entered into the upgrade mode.

Step 5.

Check to make sure the KVM cables from port 1 are connected to the host PC.

Note: A special upgrade cable is not needed to perform the upgrade since you can use the same KVM cable that you use for connecting to the computers. However, depending on the different models, the KVM cables you use will vary.

Step 6.

Click the “Browse” button and locate the firmware-upgrade file, which is indicated with a file extension such as “*.uni”.

Select the upgrade file (for example: “UCF-30-11-07.uni”) and click “Open” to load the file. Then click “Upgrade” to make it ready for upload.

16