Radio Reception
Tuning to radio stations
1Press SOURCE to select TUNER.
➜TUNER is displayed briefly.
2Press BAND (or TUNER on the remote control) once or more to select your waveband. (FM/ AM)
3Press and hold TUNE à or á.
➜The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning: SEARCH.
4Repeat step 3 if necessary until you find the desired station.
●To tune to a weak station, press TUNE à or á briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations in the memory.
Automatic programming
Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden.The system will only program stations which are not in the memory already.
1Press PRESET ¡ or ™ to select the preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2Press PROGRAM for more than 2 seconds to activate programming.
➜ AUTO is displayed and available stations are programmed in order of waveband reception strength: FM followed by AM. The last preset automatically stored will then be played.
Manual programming
1Tune to your desired station (see Tuning to radio stations).
2Press PROGRAM to activate programming.
➜PROGRAM flashes in the display.
3Press PRESET ¡ or ™ to allocate a number from 1 to 40 to this station.
4Press PROGRAM again to confirm the setting.
➜PROGRAM disappears, the preset number and the frequency of the preset station are shown.
5Repeat the above four steps to store other stations.
●You can override a preset station by storing another frequency in its place.
Tuning to preset radio stations
●Press PRESET ¡ or ™ until the desired preset station is displayed.
Changing tuning grid (not available for
all versions)
In North and South America, the frequency step between adjacent channels in the AM band is 10 kHz (9 kHz in some areas). The preset frequency step in the factory is 9 kHz.
Changing the tuning grid will erase all previously stored preset radio stations.
1Select TUNER source or in the tuner mode.
2Press STOP on the set for at least 5 seconds.
➜The display will show "GRID 9" or "GRID10".
Notes:
–GRID 9 and GRID 10 indicate that the tuning grid is in step of 9 kHz and 10 kHz respectively.
–The FM tuning grid also will be changed from 50 kHz to 100 kHz or vice versa.
English
15