Belkin F9K1001 Regulatory Information FCC Statement, Federal Communications Commission Notice

Page 39

Regulatory Information

FCC Statement

DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY

We, Belkin International, Inc., of 12045 E. Waterfront Drive, Playa Vista, CA 90094, declare under our sole responsibility that the device, F9K1001 v1, complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Exposure to Radio Frequency Radiation..

The device shall be used in such a manner that the potential for human contact normal operation is minimized.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the distance between the equipment and the receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

37

Image 39
Contents N150 Table Of Contents Where to Place Your Router Getting Started What’s in the Box Initial SetupModem How to Set It UpSetup Getting Started During setup you may be asked for additional information Advanced Tools & Settings Belkin Router Manager Belkin.310Manual Setup Using Your Browser Adding Computers to Your Network Using the CDManually Using the WPS ButtonOff Idle Wi-Fi Protected Setup WPS Light and ButtonGetting to Know Your Router Front Panel Router Status LightBack Panel Getting to Know Your RouterTechnical Details Technical Features System Requirements Setup SoftwareSetup steps Enabling Auto Update on Your Belkin RouterUsing your router Using your router Updating the Router’s Firmware via the Web Interface Using your router Using your router Using your router Resetting the Router Resetting the RouterRestoring Your Router to Factory Defaults Reset Button RedSymptoms Using your router Using your router Troubleshooting, Support, and Warranty Setup CD does not automatically startBelkin Setup cannot find my Router Belkin Setup cannot connect my Router to the Internet Troubleshooting, Support, and WarrantyCan’t connect to the Internet wirelessly Troubleshooting, Support, and Warranty Troubleshooting, Support, and Warranty Am having difficulty setting up WPA security on my Router Troubleshooting, Support, and Warranty Technical Support Australia New Zealand SingaporeEurope What the period of coverage is What this warranty coversWhat will we do to correct problems? What is not covered by this warranty?How to get service How state law relates to the warranty Federal Communications Commission Notice Regulatory Information FCC StatementCanada-Industry Canada IC Regulatory Information