Belkin PM01116EA user manual Information, Modifications, Europe-European Union Notice

Page 97

Information

Table of Contents

sections

1

2

3

4

5

6

7

8

9

10

Modifications

The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by Belkin International, Inc., may void the user’s authority to operate the equipment.

Europe-European Union Notice

Radio products with the CE 0682 or CE alert marking comply with the R&TTE Directive (1995/5/EC) issued by the Commission of the European Community.

Compliance with this directive implies conformity to the following European Norms (in brackets are the equivalent international standards).

Canada-Industry Canada (IC)

The wireless radio of this device complies with RSS139 and RSS 210 Industry Canada. This Class B digital apparatus complies with Canadian ICES-003.

Operation is subject to the following two conditions:

1)this device may not cause interference, and

2)this device must accept any interference, including interference that may cause undesired operation of the device.

Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada.

EN 60950-1 (IEC60950) – Product Safety

EN 300 328 Technical requirement for radio equipment

EN 301 489 General EMC requirements for radio equipment.

To determine the type of transmitter, check the identification label on your Belkin product.

Products with the CE marking comply with the EMC Directive (89/336/ EEC) and the Low Voltage Directive (72/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms (in brackets are the equivalent international standards).

EN 55022 (CISPR 22) – Electromagnetic Interference

EN 55024 (IEC61000-4-2,3,4,5,6,8,11) – Electromagnetic Immunity

EN 61000-3-2 (IEC610000-3-2) – Power Line Harmonics

EN 61000-3-3 (IEC610000) – Power Line Flicker

EN 60950-1 (IEC60950-1) – Product Safety

Products that contain the radio transmitter are labeled with CE 0682 or CE alert marking and may also carry the CE logo.

G+ MIMO Wireless Router

95

Image 97
Contents Wireless Router Table of Contents Introduction Advantages of a Wireless NetworkImportant Factors for Placement and Setup Placement of your G+ Mimo Wireless RouterRouter Placement IntroductionCordless Phones Choose the Quietest Channel for your Wireless NetworkSecure Connections, VPNs, and AOL Product Overview Product FeaturesSetup Assistant Built-In Dynamic Host Configuration Protocol DhcpProduct Overview Support for VPN Pass-ThroughSetup Assistant Software System Requirements Package ContentsKnowing your Router System RequirementsWireless-Computer Status Wireless SecurityWired-Computer Status Router/Power StatusInternet Status Modem StatusReset Button Red Connections to Wired Computers GrayResetting the Router Ii. Restoring the Factory DefaultsSetup Assistant Ethernet USB Connecting and Configuring your RouterModem Requirements Hardware Connections Follow the Quick Installation Guide QIG Connecting and Configuring your RouterSet Up the Router Run the Setup Assistant Software Confirmation Screen Progress Screen Checking Settings Verifying Hardware Connections Requesting Internet Account Info if needed Naming your Wireless NetworkConfiguring the Router Checking Internet Connection Congratulations Troubleshooting Connecting and Configuring your Router Hardware Connections Follow the Quick Installation Guide Alternate Setup MethodLogging into the Router Logging out of the Router Alternate Setup MethodUnderstanding the Web-Based Advanced User Interface Internet-Status Indicator Login/Logout ButtonQuick-Navigation Links Home ButtonInternet Settings LAN SettingsFeatures LanguageSetting your Connection Type Change WAN MAC Address Host NameProvided by your ISP. Enter your IP address here IP AddressSubnet Mask Provided by your ISP. Enter your subnet mask hereSetting your ISP Connection Type to PPPoE Service Name PasswordUser Name Get IP by DhcpEuropean Countries Only Service IP Address Pptp PasswordPptp Account Disconnect after X…Alternate Setup Method Setting Custom Domain Name Server DNS Settings Cloning your MAC Address Configuring your WAN Media Access Controller MAC AddressEntering a Specific MAC Address Viewing the LAN Settings Using the Web-Based Advanced User InterfaceChanging LAN Settings Using the Web-Based Advanced User InterfaceIP Pool Dhcp ServerLease Time Local Domain NameViewing the Dhcp Client List Changing the Wireless Network Name Ssid Configuring the Wireless Network SettingsUsing the Wireless Mode Switch Changing the Wireless ChannelOff 802.11g only802.11e/WMM QoS Switch Using the Broadcast Ssid Feature Protected Mode SwitchChanging the Wireless Security Settings Using Wi-Fi Protected Setup Using the Web-Based Advanced User Interface WPA2 Requirements Setting WPA/WPA2-Personal PSK Setting WPA-PSK Setting WPA SecuritySetting WEP Encryption Using a Hexadecimal Key Using the Access Point Mode Setting up an Allow Access List Setting MAC Address ControlClick Apply Changes 5 to finish Setting up a Deny Access List Configuring the Firewall Manually Entering Settings into the Virtual Server Configuring Internal Forwarding SettingsChoosing an Application Setting Client IP Filters Enabling the Demilitarized Zone DMZ Setting up the Router’s Dynamic DNS Update Client Using Dynamic DNSUtilities Restarting the Router Restarting the Router to Restore Normal OperationRestoring Factory Default Settings Saving a Current Configuration Using the Web-Based Advanced User Interface Restoring a Previous Configuration Using the Web-Based Advanced User Interface Checking for a New Version of Firmware Updating the FirmwareDownloading a New Version of Firmware Using the Web-Based Advanced User Interface Updating the Router’s Firmware Using the Web-Based Advanced User Interface Setting or Changing the Administrator Password Changing System SettingsChanging the Login Time-Out Setting Enabling Remote Management Setting the Time and Time ZoneEnabling/Disabling UPnP Enabling/Disabling Auto Firmware UpdateManually Configuring Network Settings in Mac OS up to Manually Configuring Network SettingsManually Configuring Network Adapters in Mac OS X Manually Configuring Network SettingsManually Configuring Network Settings Manually Configuring Network Settings Manually Configuring Network Adapters in Windows 98SE or Me Internet Explorer 4.0 or Higher Recommended Web Browser SettingsNetscape Navigator 4.0 or Higher Recommended Web Browser SettingsProblem TroubleshootingSolution Troubleshooting Setup Assistant cannot find my Router Setup Assistant cannot connect my Router to the Internet Troubleshooting Can’t connect to the Internet wirelessly Troubleshooting Troubleshooting C3 03 0F AF 4B B2 C3 D4 4B C3 D4 E7 E4 = 128-bit key Click OK, and then Apply to save the settings Do Belkin products support WPA/WPA2? Troubleshooting Troubleshooting Troubleshooting Technical Support What’s the difference between 802.11g and draft 802.11n?Country Number Internet adress FCC Statement InformationF5D9231-4v1 Federal Communications Commission NoticeModifications InformationEurope-European Union Notice Canada-Industry Canada ICWhat will we do to correct problems? What this warranty coversWhat is not covered by this warranty? How to get serviceHow state law relates to the warranty Restricted Use in Certain Countries Class 2 Equipment