Back

1.Video Inputs. Sources such as DVD players and computers should be connected here.

2.Video Outputs. Video displays should be connected here.

3.Power Regulator. Switch between 110V (US standard) and 220V (EU base standard).

4.RS-232 connector. Connect included RS-232 cable here if you wish to control your switcher by PC or 3rd party controller

5.TCP/IP connector. Connect to your switcher through a network by connecting an Ethernet cable here.

6.Primary and Secondary Power Supply. Connect included power cables here.

AV : Used to select input to output. Example: Input 3 to output 5 - Press 3 then AV then 5 (displays as 3AV5 on the LCD display)

“,” : Select multiple outputs with this. Example: Input 1 to output 3-5. Press 1 then AV then 3,4,5 (displays as 1AV345)

ALL : Press to connect all outputs for an input. Example: Input 2 to all outputs. Press 2ALL

Through : Sends inputs to corresponding outputs. Example: Input 4 to output 4. Press 4Through

Memory: Save the current settings for the switcher to create a reset between 0-9. Press Memory3 to save as preset 3

Recall: Uses saved presets that you’ve created. Press Recall3 to pull up what you saved with Memory3

Undo: Goes back one step, if you’ve changed the wrong item and want it to go back to what it was press undo

Enter: Used to end each selection. Example: 3AV5, press enter after to confirm your choice

<--: Used for EDID selection or as a backspace. Hold for 10 seconds for EDID commands

Toll free: 1-877-536-3976	5	atlona.com
Local: 1-408-962-0515