Atlona AT-PRO3HD44M Before You Start, Specifications, Remote Control, storms, atlona.com

Page 4
Before You Start

Before You Start

Make sure when connecting the CAT5e/6/7 cables a 568B termination method is used.

Make sure the matrix is connected to a component surge suppressor and line conditioner.

Note: Atlona’s warranty does not cover damage due to electrical disturbances. A component surge suppressor and line conditioner are highly suggested especially in areas with electrical

storms.

Be sure you’re using a mono to mono (2 conductor) 3.5mm IR cable (i.e. AT-MINIMONO6 - available to purchase at Atlona.com) when using IR output control from 3rd party controllers, stereo (3 conductor) 3.5mm cables are not compatible.

Specifications

Bandwidth frequency

6.75 Gbps

Input Ports

4 x HDMI (Female Type)

 

5 x IR 3.5mm

 

1 x Firmware update

Output Ports

4 x CAT 5e/6/7

 

4 x S/PDIF Digital Audio

 

1 x RS-232

 

5 x IR 3.5mm

Resolution outputs

Video: up to 1080p@60Hz

 

Vesa: up to 1920x1200

Dimensions (HxWxD)

1.69x17.13x10 (inch) or 42.93x435.10x254 (mm)

Weight

7lbs or 3.18kg

Power consumption

60W

Remote Control

storms.SpecificationsOutput selection. Numbers correspond with the CAT5e/6/7 category cable outputs (1-4) on the matrix.

Remote ControlManual backgroundArrow buttons are not functional for this product.

Manual backgroundManual backgroundInput selection. Numbers correspond with the HDMI inputs (1-4) on the matrix.

atlona.com

4

Toll free: 1-877-536-3976

Local: 1-408-962-0515

 

 

Image 4
Contents Atlona HDMI 4 by 4 Matrix Switcher over CAT5e/6/7 atlona.comAT-PRO3HD44M Table of Contents Package Contents FeaturesIntroduction 1 x 24V/6.25A DC adaptor 1 x Power cord 1 x IR ExtenderSpecifications Remote ControlBefore You Start stormsPanel Description Front PanelBack Panel 3rd Party Controller Set Up Connection and Installation3rd party controller to the AT-PRO3HD44M example AT-MINIMONO6 IR Remote Control Set Up AT-PRO3HDRECMatrix Front Panel Functions I/O ControlFeedback = ”Input # saved to all”EDID Set Up Feedback=Matrix Settings View I/O settingsCommand RS-232Connection CommandRS-232 Set Up Command for Matrix baud rateBaud Rate Note Baud Rate must be only 2400, 4800, 9600, 19200, 38400, 57600, orRS-232 Command for the Output baud rate status Command for Output receiver baud rateRS232para RS232paraXbaudrate,data-length,parity,stop-bitUpdating firmware Resetting to factory settingsUpdating and Resetting Safeguards Safety InformationPrecautions Warranty Limited WarrantyCustomer Remedies No other warrantiesAtlona Product Registration