8
27.Enter the TCP/IP address of the copier then type a colon: and then lp (lowercase no spaces). Just like in the example shown below:
28.Now click on the “general” tab and choose “print a test page”
29.The DP unit should produce a standard test page confirming that everything has been set up. It will also display a list of the files used.
Stage 3
Operating Instructions
30.For comprehensive operating instructions, please refer to the manual, which can be found on the CD that came with your unit.
Problems?
No Network Connection
1.Check the obvious things; is the unit switched on and
2.Check the cable connections and if possible use a known good cable and network port.
3.Have you programmed the IP address of the copier,
4.Even if you don’t have a Gateway, an address must be inputted. Choose a spare IP address for the Gateway if required.
5.Have you properly configured the LPR port on your PC? Again, refer to the start of this guide to check this.
6.Where you plug the network cable into the back of the copier, do you have a green “link light” showing. If not try an alternative network port. If you do not get a green link light, please contact your Dealer for further assistance.
30/05/02 | Document Systems Support V1.0 |