CHAPTER 2
Setting Up Your M150 FPD Monitor
This chapter describes how to set up and integrate your 3M Touch Systems M150 FPD monitor into a touch application. You need to complete the following tasks:
•Unpack the components
•Connect the video, touch screen, and power cables
•Power on the monitor and test your setup
•Install the touch screen software
•Calibrate the touch screen
System Requirements
The M150 flat panel touch monitor requires a personal computer (PC). This touch monitor will not work with Apple Macintosh computers.
The requirements for your PC are as follows:
•Your PC must have an available
•Your PC must have a video card and video driver already installed for the monitor. If you need to install a video card or a video driver, refer to your computer documentation for instructions.
•Your PC must have a unique interrupt request (IRQ) available to the touch screen COM port. The touch screen cannot share an IRQ with another device.
•If the only serial port available on your PC has 25 pins, you will need a
When choosing your workspace, select a sturdy, level surface. Also, make sure you can easily access the back of the touch monitor and the computer. Easy access helps ensure a smooth setup of the touch monitor.
Note: Before setting up your M150 FPD, refer to the Important Safety Information section at the beginning of this document.