SATO GL408e / GL412e quick start Cutting the media, Risk of injury at the simplified cutter

Page 21

GL408e / GL412e Barcode Thermal Printer

Operation

8.3 Cutting the media

You can separate the labels with the simplified cutter.

CAUTION!

Risk of injury at the simplified cutter!

The simplified cutter used to cut the labels may cause cuts and skin abrasions.

Therefore:

– Use caution when handling the simplified cutter.

– When in doubt, wear protective gloves.

1Simplified cutter (tear off blade)

Fig. 12 Simplified cutter

To separate the labels:

1.Print a label.

2.Pull lightly down the label (1), from one media edge to the other.

Fig. 13 Label

18

Image 21

Contents Quick Start Guide Table of contents General General Important informationLimitation of liability Copyright Explanation of symbols Intended use SafetyOperating Tips Electrical Transport and storage Transport informationStorage Unpacking the printer Installation Parts and functions OverviewCable hook LED Cancel buttonDisplay Direction keysConnecting the device Setup and initial operationInserting media, printer Inserting mediaInserting ribbon, front Inserting ribbonUser mode Changing settingsOperation PrintingOption mode Interface modeEmulation mode Advanced modeRisk of injury at the simplified cutter Cutting the mediaRisk of environmental damage in case DisposalInappropriate disposal WEEE/RoHS StatementGeneral information Technical dataConnection values Operating conditionsModels GL408e / GL412e Printing properties Value Unit Other specificationsDisposal Index