SATO MB200 manual Std

Page 25

Over 30mm

Dispense mode
Labels	Non-dispensed
	label

First perform steps 1 through 5 on pages 23 and 24 (Continuous mode)

(1)Pick the Dispense/Continuous switch lever from both sides, and

slide the Dispense unit to the direction of the arrow.

*Leave more than 30mm of the label out for the Dispense mode.

*Slide the Dispenser unit until it is set in place.

*Always set the Dispenser unit back to the Continuous mode when

opening/closing the cover.

At the Continuous mode

STD

	At the Dispense mode
PN9001122		DSP	Page 25

4

Before Starting

Image 25

Contents User’s Guide Barcode PrinterIntroduction Features of MB200 Table of Contents Markings and Symbols Safety PrecautionsSymbol example Foreign Matter LiquidsDropping and Damage Battery Pack DisassemblyAbnormal Conditions AC Adapter / Battery Charger Optional Location PowerEasy Cutter Thermal Head and Stepping MotorNot using the printer for a long time Replacing the Battery PackMaintenance and Cleaning Precautions in Use Unpacking UnpackingPart Names PN9001122 Name and Function of Operating Parts Before Starting Charging the Battery PackCharging Time Installing and removing the Battery Pack PN9001122 Using the AC Adapter Loading Labels Page STD Changing Roll Width Turning the Power on and off Starting the Printer Procedures for Online Operation Off Put on the interface protector optional On-line OperationPN9001122 DIP Switch DSW1 DIP Switch 2 DSW2 IrDA Adjustment Lever PN9001122 Test Printing Mode Trouble Shooting PN9001122 Cleaning the Thermal Head Daily MaintenanceCleaning the Platen/Dispense Rollers Options ReferenceUser options Factory Installed Options Non-separated Labels When the next printing is not performed Ordering Repairs Basic Specifications PN9001122 Service Sato America, Inc