To change the port setting, click on the ID parameter to enter to the selected port to configure its Speed/Disable, Flow control and Port Bandwidth Rate Control Ingress and Egress.
Figure 17.
Speed/Disable:
This setting has six
Flow Control:
This setting determines whether or not the Switch will be handling flow control. Set FlowCtrl to Enable to avoid data transfer overflow. Or it sets to Disable; there is either no flow control or other hardware/software management.
When the 10/100M port is set to full duplex mode, then the flow control will automatically set to disable; and if the 10/100M port is set to half duplex mode, the flow control will automatically set to enable.
Bandwidth Rate Control Ingress/Egress rate:
This Switch support the Port Bandwidth Rate Control, and will work only on the auto mode.
VLAN Settings (Virtual Local Area Network)
Group individual ports into a small “Virtual” network of their own to be independent of the other ports. To add a VLAN group, press “Add Group” button, the new VLAN configuration window will pop out, you can fill in the description in order to describe this VLAN Group, check on the port to be a member to this VLAN Group, and press “Apply” button to execute the setting.
Figure 18. VLAN Group Settings
Once you want to modify the VLAN Group, check on the ID parameter, the ID VLAN configuration window will pop out.
Figure 19. VLAN Settings
29 | 30 |