Trunk Setting
The Trunk function enables to cascade two or more devices with a larger bandwidths.
There are three Trunking groups to be set; and there are default ports in each member. Checked “Enable” to use the trunk function, select the ports in each member to be trunk, and click “Apply” to activate the selected trunk group.
Figure 20. Trunk Settings
Be sure that the selected trunk setting port must connect to the device with a same VLAN group.
Mirror Setting
Port Mirroring is a method of monitoring network traffic that forwards a copy of each incoming and/or outgoing packet from one port of a network switch to another port where the packet can be studied. It enables the manager to keep close track of switch performance and alter it if necessary.
Configuring the port mirroring by assigning a source port from which to copy all packets and a sniffer port where those packets will be sent.
The selection of the sniffer mode is as follow:
TX (transmit) mode: this mode will duplicate the data transmit from the source port and forward to the sniffer port.
RX (receive) mode: this mode will duplicate the data that send to the source and forward to the sniffer port.
Both (transmit and receive) mode: this mode will duplicate both the data transmit from and data that send to the source port, then it will forward to the sniffer port.
Figure 21.
31 | 32 |