BASIC SETUP OF YOUR LTB
Before using the LTB, please read and follow the steps listed below:
1.IMPORTANT Heed all safety warnings when operating the LTB.
2.Please be sure to check for these items. The LTB sound system comes complete with 2
3. Make sure the power switch is in the OFF position, the EQ, LOW, MID and HIGH tone controls are in their 12 o’clock notched positions and all channel LEVELS, the MAIN and the REV are in their MIN positions.
Stereo Cassette
P O W E R
4.Next, plug the supply cord into a power source with the correct voltage.
5.Connect the speaker cables 
from the LTB’s SPEAKER OUTPUT jacks located on the rear of the LTB mixer to the input jacks
on the speaker cabinets. | 80W | |
4Ω MIN. LOAD TOTAL | ||
|
6.Connect the cord(s) from any microphones, instruments, outboard gear or other signal source(s) to the appropriate input jack(s) on your LTB.
This full page illustration can be found on page 8.
7.Turn all instruments, outboard gear and other equipment ON before powering up the LTB.
8.Slowly raise the MAIN volume control to its 12 o’clock position. Next, slowly bring up the appropriate channel input level control (ie: if the microphone is plugged into the channel 1 inputs, the appropriate channel control is labeled 1), listening for the onset of feedback or howling or until the desired level is reached. The LTB’s overall volume can be increased by rotating the MAIN
control clockwise.
9. If using external signal processing
devices, slowly raise the appropriate channel EFX control until the desired level is reached (ie: if the microphone is plugged into the channel 1 inputs, the appropriate channel control is labeled 1).
10.When shutting down the LTB, turn OFF the LTB FIRST then any additional outboard gear, instruments or other equipment.
For more detail on setting up your LTB, please refer to the diagrams on pages 9 and 10.
6