TRENDnet User’s Guide
To reconfigure an additional Powerline adapter to connect and use the encryption key of your existing Powerline network:
1.Verify that all existing Powerline adapters are already installed and connected.
2.Push and hold the Sync button on the additional Powerline adapter for 10 seconds and release it. All LEDs will turn off and turn back on. This will erase the current encryption key assigned to the additional Powerline adapter.
3.Push and hold the Sync button on one of the existing Powerline adapters connected to your Powerline network for 2 seconds and release it. The Power (PWR) LED will start blinking.
4.Within 2 minutes, push and hold the Sync button on the additional Powerline adapter for 2 seconds and release it. The Power (PWR) LED will start blinking. This will reconfigure your additional Powerline adapter to connect and use the encryption key of your existing Powerline network. All LEDs will turn off and turn back on and the Powerline (PL) LED will turn on the adapters are connected.
To reconfigure the encryption key and connect additional Powerline adapters to your existing Powerline network, repeat the steps above for each adapter.
Using the Powerline Utility
The Powerline Utility allows you to do the following:
∙Create a customized encryption key for your Powerline network and apply it to multiple Powerline adapters at the same time.
∙Allows you to view the Powerline adapters connected to your network (using the MAC address) and the approximate connection quality and speed of each Powerline adapter
∙View and upgrade your Powerline adapter firmware version.
Note: Link speed displayed in the utility of your Powerline adapters to another through your electrical system is estimated. Actual link speed may vary.
Before installing and using the utility, please ensure the following:
∙Write down the Device Password (DPW)
“Product Hardware Features” on page 2.
∙Make sure your computer in which you are installing the utility is connected to your network and your Powerline adapters are also connected to your network.
∙If you have changed your encryption key using the Sync button and you are creating a customized encryption key, it is required to reset all Powerline devices to defaults using the physical Reset button on your Powerline adapter first before using the utility. See “Product Hardware Features” on page 2.
∙Please ensure that your Powerline adapters are already installed and connected and the Ethernet port on each adapter is connected to a device powered on.
Powerline Utility System Requirements
| Supported Operating Systems | CPU | Memory | |
|
|
|
|
|
| Windows 7 | 1GHz or above | 1GB RAM or above | |
|
|
|
|
|
| Windows Vista | 800MHz or above | 512MB RAM or above | |
|
|
|
|
|
| Windows XP | 300MHz or above | 256MB RAM or above | |
|
|
|
|
|
|
|
|
|
|
© Copyright 2012 TRENDnet. All Rights Reserved.
9