Fujitsu S6231 Primary Master Submenu of the Main Menu, Menu Field Options Default Description

L i f e B o o k S S e r i e s N o t e b o o k B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

*Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylinders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [TOSHIBA MK4025GAS -(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
LBA Format		installed here.
Total Sectors:	78140160
Maximum Capacity:	40008MB	[Auto]
		The BIOS auto-types the
Multi-Sector Transfers:	[16 Sectors]	drive on boot time.
LBA Mode Control:	[Enabled]
PIO Transfer Mode:	[Multiword DMA 2]	Except [Auto]
DMA Transfer Mode:	[Disabled]	You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

			Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field	Options	Default		Description
Type:	• Auto	[Auto]		Selects the ATA/ATAPI device type. Select Auto to have the type automati-
	• None			cally identified by the BIOS at POST. If None is selected, all of the following
	• CD-ROM			Set-up items do not appear. Select CD-ROM if a CD-ROM drive is installed at
	• Hard Disk			this connection. If Hard Disk is selected, you must specify the number of Cyl-
				inders, Heads, and Sectors for the drive.
CHS Format (Cylinders, Heads, Sectors)
Cylinders:	• A number	–—		This appears only when Hard Disk is selected. When Hard Disk is selected,
	between 0			you can change the value. This field is incremented by pressing the [Space-
	and 65,535			bar]). This field is decremented by pressing the [-] key. You can also change
				the field by typing in the number.
Heads:	• A number	–—		This appears only when Hard Disk is selected. When it is selected, you can
	between			change the value. This field is incremented by pressing the [Spacebar]). This
	1 and 16			field is decremented by pressing the [-] key. The field can also be changed by
				typing in the number.

6