Fujitsu N6110 manual Primary Slave Submenu of the Main Menu

L i f e B o o k N S e r i e s N o t e b o o k B I O S

Primary Slave Submenu of the Main Menu

The Primary Slave submenu allows you to configure secondary ATA devices.

PhoenixBIOS Setup Utility

Main

Primary Slave [HL-DT-ST DVDRAM GMA-4080N-(PS)]		Item Specific Help
Type:	[Auto]	Select Serial ATA/ATAPI
		drive installed here.
Multi-Sector Transfers:	[Disabled]
LBA Mode Control:	[Disabled]	[Auto]
Transfer Mode:	[Multiword DMA 2]	The BIOS auto-types the
Ultra DMA Mode:	[Mode 2]	drive on boot time.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 3. Primary Slave Submenu

Table 3: Fields, Options and Defaults for the Primary Slave Submenu of the Main Menu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	NOTE: The Type field does not appear as a drop-down menu. Tap
	■	None		the spacebar to cycle through the selections.
	■	CD-ROM		Selects the ATA/ATAPI device type. Select Auto to have the type
	■	Hard Disk
				automatically identified by the BIOS at POST. If None is selected, all
				of the following Set-up items do not appear. Select CD-ROM,
				SuperDisk or Hard Disk for appropriate drive type installed at
				this connection.
CHS Format				Cylinders/Heads/Sectors
Cylinders:	■	A number between	–—	This item appears only when Hard Disk is selected as the type. This
		0 and 65,535		field is changed by incrementing (pressing the [Spacebar]) or by typ-
				ing in the number.
Heads:	■	A number between	–—	This item appears only when Hard Disk is selected as type. You can
		1 and 16		change the value by incrementing (pressing the [Spacebar]) or by
				typing in the number.
Sectors:	■	A number between	–—	This item appears only when Hard Disk is selected as type. You can
		0 and 63		change the value by incrementing (pressing the [Spacebar]) or by
				typing in the number.

8