Features | Temperature / system monitoring |
Fan control
The fans are controlled according to temperature.
Sensor monitoring
The removal of, or a fault in, a temperature sensor is detected. Should this happen all fans monitored by this sensor run at maximum speed, to achieve the greatest possible protection of the hardware.
Voltage monitoring
The most important voltages are monitored. When a voltage exceeds warning level high or falls below warning level low an alert will be generated. Adequate measurements can be done by running agents.
Cover monitoring
Unauthorised opening of the cover is detected, even when the system is switched off. However, this will only be indicated when the system is switched on again
System Event Log (SEL)
All monitored events of the system board are recorded in the System Event Log. They could be retrieved after a system reboot via ServerView.
D2530 (Econel 200 S2) | Technical Manual | 19 |