Features | Connectors and jumpers |
LAN connector
On this system board you will find a LAN controller integrated in the Intel® 6321 I/O controller Hub (ICH). This controller is supported by an external chip (Intel® Single 1 GB PHY 82564EB), which is connected to the I/O controller Hub via an original Intel interface (Kumeran Interface). The LAN controller supports the transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s and supports WOL function through Magic Packet™.
It is also possible to boot a device without its own boot hard disk via LAN. Here Intel PXE is supported.
The LAN controller connector is equipped with two LEDs (light emitting diode) indicating the transfer rate and the activity.
1 |
|
|
|
|
|
|
|
|
| 2 |
Figure 6: LAN connector |
|
|
| |
1 | LAN link/activity | green | on | LAN connection |
|
|
| off | no LAN connection |
|
|
| flashing | LAN transfer |
2 | LAN transfer rate | green + orange | off | transfer rate 10 Mbit/s (or no |
|
|
|
| connection) |
|
| green | on | transfer rate 100 Mbit/s |
|
| orange | on | transfer rate 1000 Mbit/s |
D2530 (Econel 200 S2) | Technical Manual | 23 |