Fujitsu ADA-16FX manual Ethernet connector, Edge Connectors X2, X3, Connector MCU Pins

ADA-16FX-ETHERNET

Chapter 5 Connectors

5 Connectors

5.1Ethernet connector (X1)

This is the Ethernet jack for connecting the ADA-16FX-ETHERNET to the Ethernet. The connector complies with the 10BaseT standard. The used connector has integrated transformers for transmit and receive lines.

The Ethernet jack and the Ethernet controller depends on the power supply voltage:

Supply Voltage	Used jack	Ethernet Chip	Adapter Board		Rx		Tx
					Transitions		Transitions
5V	Halo HFJ11-	CS8900CQZ	ADA-16FX-		1:1		1:1.41
	1043E		ETHERNET
3V3	Halo HFJ11-	CS8900CQ3Z	-	1:1		1:2.5
	1041E

5.2Edge Connectors (X2, X3, X11)

The edge connectors are assembled on the bottom side of the adapter board. They are used to attach the ADA-16FX-ETHERNET adapter board to the SK-16FX-EUROSCOPE (SK- 16FX-100PMC) evaluation board. All used signals are provided by the edge connectors.

Connector		MCU Pins
X2	(1 – 20)	1	– 20
X3 (71 – 100)		71	– 100
X11	(51 – 70)	51 – 70

The adapter board is powered via the edge connectors.

UG-960011-11 - 10 - © Fujitsu Microelectronics Europe GmbH