Manual Setup
FRANÇAIS ENGLISH
If the monitor is in standby mode (STANDBY ON), it
might automatically turn off while you are waiting for it to warm up.
To disable the Windows energy saving feature by clicking on the START button and selecting
SETTINGS, CONTROL PANEL,
DISPLAY, SCREEN SAVER. Make sure that the ENERGY SAVING
FEATURES OF MONITOR check boxes are either empty, or that the features are set to at least 20 minutes.
Your system may also have its Power Saving utility enabled through the Bios Setup Utility. Refer to your system manual for directions on disabling that bios option.
Normally, you can complete the setup procedure using AUTO SETUP, however, if your screen image is still distorted after you perform AUTO SETUP or the setup diskette does not run on your system, perform MANUAL SETUP.
1.Have your computer and monitor turned on for at least 15 minutes until the monitor and video adapter have warmed up.
2.You may wish to start the program you most often use so that you can adjust for a “typical” screen.
3.Press the OSD Enter button 
at the bottom of the monitor to display the initial OSD menu.
4.Use an Arrow button ( - or + ) to select the IMAGE LOCK icon 
and
press the OSD Enter button 
to access the function.
5.Using an Arrow button ( - or + ), select MANUAL, press 
and then
press 
once to select COARSE. Left and right arrow adjustment indicators become illuminated (see page 17).
6.Use the Arrow buttons to correct (as much as possible) for noise in the
video signal then press 
to save the changes.
7.Use an Arrow button to select FINE and press the 
button.
8.Use the Arrow buttons again to tune the image to your liking.
9.When finished, press the Exit button 
four times to exit from the OSD.
ITALIANO ESPAÑOL
You have completed the monitor setup.
COMPL & WARR JAPANESE
13