IBM 9511-A, T540 manual T54A-E.book Page 23 Saturday, February 19, 2000 1205 PM

T54A-E.book Page 23 Saturday, February 19, 2000 12:05 PM

2.Carefully insert the head of a flathead (–) screwdriver into the slot visible along either side of the cable cover (a) and pry it off.

FRANÇAIS ENGLISH

a

b

c

3.Squeeze the sides of the hinge cover (b) and pull it off.

4.Gently lift the stand cover (c) along the top and then slide it backwards and off the stand.

5.Remove the signal cable and the power cord from the monitor by disconnecting the corresponding adapters. Carefully cut the plastic tie to free the power cord and remove the screw holding the power cord clamp.

6.Lay the monitor facedown on a cushion and remove the six screws holding the hinge mechanism on the monitor. Lift off the hinge and base assembly.

7.If you are installing an arm or wall-mounting device, follow the directions included with the device. If you are just changing your cables, continue with Step 8.

8.Connect the signal cable and the power cord, then refit the power cord clamp in its original screwpost.

9.Slide the stand cover back on the stand.

10.Put the hinge cover back on, making sure that the straight side is at the top.

11.Insert the three tabs at the top of the cable cover into the slots in the back of the monitor and push the cover into place.

To obtain the correct cables and/or to get further instructions on installing them, call the IBM HELPCENTER at the above numbers or contact your dealer, retailer, or other IBM authorized Servicer.

23

COMPL & WARR JAPANESE ITALIANO ESPAÑOL