IBM L191p manual Connecting your Monitor for Digital, Dvi

Page 10

Connecting your Monitor for Digital

1.Turn off your computer and all attached devices.

a

2.Tilt monitor all the way forward.

3.Connect the DVI connector at the end of the DVI-D signal cable (shipped with your Monitor) to the DVI port located on the back of the Monitor. See picture below.

Connecting DVI Cable

DVI

Cable

8

Image 10

Contents L191p IBM ThinkVision L191p MonitorFirst Edition May /2004 Contents Page Product Description Setting up the monitorHandling Instructions Height Workplace PreparationOrientation Viewing Angle Adjusting the Monitor PositionWorking Practices BackCaring for your Monitor Screen settingsEyesight Connecting your Monitor for Analog EnglishConnecting your Monitor for Digital DVISwitching on your Monitor Installing the Windows XP device driver Device Driver InstallationInstalling the Windows Me device driver Installing the Windows 2000 device driver Installing the Windows 98 device driverInstalling the Windows 95 device driver Select Device window, click Have Disk Auto Image Setup Analog Only Auto Image SetupAuto Image Setup for DOS Operating system installation steps \TESTPATOperating system, go to .Auto Image Setup for DOS on Manual Image Setup User control features Adjusting Your LCD MonitorUser controls Operation OSD Lock / UnlockOn-screen display OSD controls Initial appearance of OSD OSD functionsOSD Icon on Submenu Description Controls Options Adjusts menu location on the screen Further Information Display modesFor image problems, you Factory Set Display ModesPower Management Product DisposalTroubleshooting For AnalogUser Problem Possible Suggested Action Reference Cause Further Help Specifications DVIFrançais English Service Information This section contains information on notices and trademarks Trademarks