IBM L170p manual Auto Setup Analog Only

Page 15

Auto Setup (Analog Only)

ENGLISH

Auto Setup

The Setup Utility included on the setup diskette is for displaying dot patterns. They do not replace or modify the display driver.

The Auto Setup instructions require the monitor to be warmed up for 15 minutes. This is not required for normal operation.

By pressing the key, you will have direct access to the Image Setup control that is used during the Auto Setup process.

When you first use your monitor you must perform Auto Setup. This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Auto Setup, the settings are stored and used each time you turn on the monitor.

To optimise the displayed image a set-up utility is provided on the CD. Operation of the utility is dependent on the operating system on your computer. For correct operation locate the operating system on your computer from the table below and follow the appropriate instructions. You can choose to run AUTO SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO SETUP for both Windows and DOS. You can run versions of AUTO SETUP in any order.

FRANÇAIS

ESPAÑOL

The AUTO SETUP process only applies to the current

screen mode. When a new mode is selected, repeat this section to reset the monitor

Operating System

Corresponding Auto Setup procedure

 

 

 

 

DOS

Auto Setup for DOS on page 14

 

 

Windows 3.1, Windows 95,

Auto Setup for Windows 3.1, Windows 95,

Windows 98, Windows 2000,

Microsoft Windows NT®,

Windows 98, Windows NT, Windows 2000,

Windows Me or Windows XP on page 15

Windows Me or Windows XP

 

Before you begin AUTO SETUP for your computer:

1.Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the Table on page 24.

You should perform AUTO SETUP for each screen mode you use.

COMPL & WARR JAPANESE ITALIANO

13

Image 15
Contents IBM ThinkVision L170p Monitor L170pFirst Edition April/2003 Contents Page Setting up the monitor Product DescriptionHandling Instructions Adjusting the Monitor Position Workplace PreparationWorking Practices Hands Screen settingsCaring for your Monitor BackConnecting your Monitor for Analog Connecting your Monitor for Digital Switching on your Monitor Device Driver Installation Installing the Windows XP device driverInstalling the Windows Me device driver Installing the Windows 98 device driver Installing the Windows 2000 device driverInstalling the Windows 95 device driver Select Device window, click Have Disk Auto Setup Auto Setup Analog OnlyAuto Setup for DOS \TESTPAT Operating system installation stepsPage Manual Setup Adjusting Your LCD Monitor User control featuresUser controls OSD Lock / Unlock OperationOn-screen display OSD controls Initial appearance of OSDOSD functions Manual OSD Icon on Controls Display modes Further InformationFactory Set Display Modes Product Disposal Power ManagementFor Analog TroubleshootingUser Problem Possible Suggested Action Reference Cause Further Help Supply combined SpecificationsFrançais English Compl & Warr Japanese Italiano Español Model Type Service InformationThis section contains information on notices and trademarks Trademarks