IBM L170m manual Operating System Corresponding Auto Setup procedure

Auto Setup

ENGLISH

Auto Setup

The Setup Utility included on the installation

CD is for displaying dot patterns. They do not replace or modify the display driver.

The Auto Setup instructions require the monitor to be warmed up for 15 minutes. This is not required for normal operation.

By pressing the Auto key, you will have direct access to Auto Adjustment.

When you first use your monitor you must perform Auto Setup. This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Auto Setup, the settings are stored and used each time you turn on the monitor.

To optimise the displayed image a set-up utility is provided on the CD. Operation of the utility is dependent on the operating system on your computer. For correct operation locate the operating system on your computer from the table below and follow the appropriate instructions. You can choose to run AUTO SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO SETUP for both Windows and DOS. You can run versions of AUTO SETUP in any order.

FRANÇAIS

ESPAÑOL

The AUTO SETUP process only applies to the current

screen mode. When a new mode is selected, repeat this section to reset the monitor.

Operating System	Corresponding Auto Setup procedure
DOS	Auto Setup for DOS on page 12
Windows 95, WIndows 98,	Auto Setup for Windows 95, Windows 98,
Windows 2000,
Microsoft Windows NT®,	Windows NT, Windows 2000, Windows Me or
	Windows XP on page 13
Windows Me or Windows XP

Before you begin AUTO SETUP for your computer:

1.Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the Table on page 21.

You should perform AUTO SETUP for each screen mode you use.

COMPL & WARR JAPANESE ITALIANO

11